PELCO® Dimpler™

Created by Kathleen Patrick, Modified on Mon, 10 Jun at 12:55 PM by Kathleen Patrick

PELCO® Dimpler™ Tool Repadding

Product No. 83060, 83061, 83062, 83063, 83064


The polishing cloth on PELCO® Dimpler™ Tools eventually wears out or becomes contaminated; this replacement padding kit makes it simple to mount new cloth on the PELCO® Dimpler™ Tools. The Repadding Tool Kit (Part #83060) consists of an aluminium Mandrel, a replaceable Glass Slide, and the Slide Holder Base (shown on the left in Figure 1 below). The Mandrel fits the arbor on the Tool, while the Base and Slide provide a clean, stable surface on which to roll the adhesive cloth of the Repadding Strips onto the Tools. The pre-cut cloth strips are supplied separately in packages of 10. The Repadding Strips are available for all of the padded PELCO® Dimpler™ Tool sizes, including the 2iM 1/8” wide Standard Tool (#83013) and the 1/8” (#83011), 1/4” (#83036), and 1/2” (#83037) wide Large Area Tools. The various Tool sizes and several Repadding Strips are shown below in Figure 1.


Figure 1: Repadding Tool Kit shown with PELCO® Dimpler™ Tools and Available Repadding Strips


APPLICATION

1) Each set of Repadding Strips is adhesive-backed. When preparing to repad a Tool, ensure the Tool core is clean and oil-free, then remove one of the pre-cut cloth strips from the sheet of 10 as shown in Figure 2 below. 


2) Each Repadding Strip has a white backing attached to it as shown in Figure 3. To start, peel the edge of this backing away from the cloth.


3) Then, take the end of the cloth and align it with the tool as shown in Figure 4.


4) Next, firmly press down and begin to rotate the Tool in one hand while peeling the cloth away from the backing with the other (Figure 5). While applying the cloth to the Tool, it is important to maintain the correct tension on the cloth such that when ends meet, the cloth edges almost touch.

Figure 2: Repadding Strips and an Unpadded 1/2” Large Area Tool Core


Figure 3: Separating the Backing from the Repadding Strip


Figure 4: Aligning the Repadding Strip onto the Tool


Figure 5: Wrapping the Cloth around the Tool


5) Then press these ends down/together onto the tool (Figure 6). The cloth will relax slightly over time, and getting the tension correct ensures that gap at the joint is minimal. A small gap has been found to be acceptable and does not impede sample processing.

Figure 6: Joining the Cloth around the Tool


6) Finally, roll the tool under firm pressure against the glass slide as shown in Figure 7. This will ensure that the thickness of the Repadding Strip is even and there are no air bubbles. In the case that a gap opens at the edges of the Repadding Strip as the adhesive relaxes, press the ends together and roll the tool again to close the gap and ensure sticking of the Strip.

Figure 7: Rolling the Tool to Even Out the Padding and Activate the Pressure-Sensitive Adhesive


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article